EN 9053 Digital Position Indicators Plastic, Electronic, 6 Digits LCD Display

The particular advantage of electronic position indicators is their programmability. Almost any desired counting option can be set directly on the device using the function buttons.

The following settings can be configured using the 4 function buttons:

• Selecting incremental or absolute measurement mode
• Changing the unit of dimension (mm, inch or degree)
• Resetting the counter or setting an offset value
• Changing the display value after one turn
• Changing the resolution, i.e. the number of displayed decimal places
• Changing the direction of rotation or counting
• Changing the display orientation (based on the installation orientation)
• Setting the maximum speed of rotation

The lithium battery is included and has a service life of up to 5 years. Time to replace the battery is indicated by a symbol on the display. Battery replacement is easy - simply remove the front cover.
The position indicators are available with protection class IP 65 or IP 67 and are suitable for corresponding ambient conditions.

Regarding the mounting options and external architecture, electronic position indicators EN 9153 with data transmission via radio frequency are very similar to mechanical position indicators EN 953 / EN 953.2 and can normally be substituted for the latter. See also „Further Information for Position Indicators“.

When mounting the position indicator, an appropriately situated mounting hole is required for the torque support.

If the position indicator is used with smaller shaft diameters, the hollow shaft diameter Ø 20 H7 can be reduced with adapter bushings EN 952.1.

Clamping plates GN 9053.6 can be used to clamp spindles after adjustment to secure them against independent or accidental turning.

If reduction is desired in addition to installation of a control knob, control knobs GN 957 are available, which combine both functions in a single element.

The information in the operating instructions must be observed during installation, initial operation, and use. These are enclosed with the product or are provided digitally on the product page.