Leveling feet GN 343.3 can bear high static loads through the use of a high quality plastic material, coupled with a design that distributes the load over a larger area.
Exceeding the static values listed in the table can result in damage to the plastic base.
The values in the table were determined by a series of tests, where a limited number of leveling feet were subjected to a vertical static load, in relation to the foot, for a limited time.
Depending on the application and load case, however, a safety factor must be considered so that the permissible load capacity is below the value given in the table.
These leveling feet are supplied assembled but can be disassembled.
Specification
Base
Plastic
Technopolymer (Polyamide PA)
Glass fiber reinforced
Temperature resistant up to 212 °F (100 °C)
Black, matte finish
Tapped socket
Steel, zinc plated, blue passivated finish
Rubber pad
Perbunan® (NBR) 70 Shore A
Black
RoHS
On request
ESD version
(conductive plastic to avoid static charge; see also GN 343.1, type KSE or KRE)
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.030 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 1-800-397-6993
